From: Design and fabrication of adjustable red-green-blue LED light arrays for plant research
Design 1 – 4 × 5 RGB Arrays | Design 2 – 1 × 36 RGB Arrays |
---|---|
20 – NorLux HEX LED 90 Die, RGB Array, Part Number N9100-0005 4 – 14" × 18" × 3/4" aluminum blocks 4 – alloy heat sinks, approximately 5" × 3" base 2 – 12 VDC, 25 A Regulated Switching Power supply 6 – 3" (80 mm) 12 VDC fan 12 – 1 K ohm potentiometer 12 – LM317 voltage regulator with matching heat sink 12 – SPST switch 4 – 5-input RJ11 coupler on single telephone cable 12 – RJ11 connector 1 – large plastic project box 2 – terminal bus, 1 ea per power supply 2 – 110 VAC standard 24 h timer 12 – 1.0 μF capacitor 12 – 0.1 μF capacitor 12 – 1 Ω power resistor 12 – 1 K Ω resistor 1 – blank circuit board | 36 – NorLux HEX LED 90 Die RGB Array, Part Number N9100-0005 1 – 20" × 20" × 1/8" sheet of aluminum 1 – 24" × 24" × 3/8" sheet of gray CPVC plastic 1 – 48" × 48" × 1/4" sheet of clear polycarbonate plastic 1 – 8" × 16" × 6" NEMA waterproof Fiberglas composite electrical box 1 – 15 VDC, 22 A Regulated Switching Power Supply 1 – 25 A 110 VAC breaker 2 – 3" (80 mm) 110 VAC fan 1 – 5" (120 mm) 15 VDC fan 36 – 22 Ω, 2 W composite resistor 72 – 20 Ω, 1 W composite resistor 108 – TIP107 NPN Regulated Transistor 108 – 4.7 K Ω 1 W composite resistor 1 – Pulse Wave Modulator (manufactured by NorLux) 3 – Blank prototype circuit board Misc. – Connectors, wire and cables, stainless steel nuts, bolts, and screws. |
Telephone cable, 2-pair, 22 AWG Misc. – wire and cable, stainless steel nuts, bolts and screws. |  |